SpeedyBee F405 WING FC board:

MCU: STM32F405,168MHz,1MB Flash

IMU(Gyro&Accelerometer): ICM-42688-P

Barometer: SPL006-001

OSD Chip: AT7456E

Blackbox: MicroSD Card Slot

UART: 6 sets(USART1, USART2, USART3, UART4, UART5, UART6(Dedicated for Wireless board Telemetry connection))

I2C: 1x Used for magnetometer, digital airspeed sensor

ADC: 4x (VBAT, Current, RSSI, Analog AirSpeed)

PWM: 12x (11+1“LED”pad)

ELRS/CRSF receiver: Supported,connected to UART1

SBUS: Built in inverter for SBUS input (UART2-RX)

LED: 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red) 1x RGB

RSSI: Supported,Named as RS .

Supported FC Firmware: INAV:SpeedyBeeF405WING(default)ArduPilot: SpeedyBeeF405WING

Weight: 8.9g

SpeedyBee F405 WING PDB board:

Input voltage range: 7~20V (2~4S LiPo)

Battery Voltage Sensor: Connect to FC board VBAT, 1K:10K (Scale 1100 in iNav, BATT_VOLT_MULT 11.0 in ArduPilot)

Battery Current Sensor: 90A continuous, 215A peak Connect to FC board Current (Scale 195 in iNav, 50 A/V in ArduPilot)

TVS Protective diode: Yes

FC BEC output: Output 5.2V +/- 0.1V DC Continuous current 2.4 Amps, 3A Peak Designed for FC, Receiver, GPS module, AirSpeed module, Telemetry module, WS2812 LED_Strip

VTX BEC output: Output 9V +/- 0.1V DC Continuous current 1.8 Amps, 2.3A Peak Voltage adjustable, 9V Default, 12V or 5V via jumper Designed for Analog Video Transmitter,Digital Video Transmitter, Camera.

Servo BEC output: Output 4.9V +/- 0.1V DC Continuous current 4.5 Amps, 5.5A Peak Voltage adjustable, 4.9V Default, 6V or 7.2V via jumper Designed for Servos.

Weight: 11.4g

SpeedyBee F405 WING Wireless board:

Wireless Configuration (long press BOOT button for 6 seconds to switch modes):

1. BLE mode, connect to Speedybee APP

2. Wi-Fi mode, connect to QGroundControl APP, Speedybee APP, MissionPlanner, etc.

3. Classic Bluetooth SPP mode, connect to QGroundControl APP, MissionPlanner

LED strip controller:

(short press BOOT button to switch effects, long press 2 seconds to switch modes)

1. 4x WS2812 LED strip connectors, adjustable colors and flashing modes

2. Max 5.2V 1.3A, supports around 70pcs 5050 WS2812 LED beads

On-board battery level indicator: 4x RGB indicator LED for battery level display by number of lights

Weight: 4.2g